Home Library Explore SAT

Home Library Explore SAT

Hand fitting knowledge test Flashcards | StudBud

Explore/Hand fitting knowledge test

WHICH OF THESE TOOLS CAN BE USED FOR MARKING OUT?

What datum is not used in bench fitting ?

Hand fitting knowledge test

10 terms·StudBud Administration·58 plays

check your knowledge on the above

Flashcards10 cardsFPractice quizPHost liveL

Questions 10

Answers

1
What datum is not used in bench fitting ?
Linear datum
Circular datum
edge datum
Point datum
2
WHICH OF THESE TOOLS CAN BE USED FOR MARKING OUT?
Radius gauge
Micrometer
Feeler gauge
Thread gauge
3
Spot the odd one out -a vernier calliper can measure:
angle of faces
depth of holes
Diameter of bars
diameter of holes
4
The size of a taping drill is:
The same diameter as the thread
Slightly larger than the diameter of the thread
Slightly larger than the core of the thread
The same size as the core of the thread
5
Draw filing is when you:
File away from you in one direction only
Hold the file sideways and move it back and forth across the surface.
File across the block at 45 degrees to the face then change the direction
file towards you
6
Which statement is not true about scrapers
Can be used to produce accurate flat surfaces
Clean taps before they are used to cut threads
Remove high spots in plain bearings
Produce oil holding depressions in slideways
7
What tool should be used first when cutting an external thread?
DIE
Intermediate tap
Taper tap
Plug tap
8
What tool should not be used in a pillar drill ?
TAP
Machine Reamer
Countersink
COUNTERBORE
9
What workholding technique would be the best for holding a round bar for marking out
Combination set
Toolmakers clamp
Angle plate and clamps
Vee block and clamp set
10
Which of these statements is not true
A reamer can produce an accurate hole diameter
A reamer can drill holes at angles
A reamer can be used to make an interference fit for pins
A reamer leaves a good surface finish