2021 Medical Gas Pre-test #1

For Medical air systems, piping shall be hard-drawn, seamless copper tube type ___

Bulk nitrous oxide system consists of more than _________ of gas.

An assembly of equipment that holds a capacity of oxygen in use and storage greater than __ is defined as a Bulk System.

Who shall be responsible for developing an emergency plan in the event of medical air loss at a Category 2 facility?

Medical air filters shall be sized for 100% of the system peak demand and be rated for a min of ___ efficiency at ___

In a medical gas system with emergency reserve, which alarm system(s) will activate when, or just before changeover?

The minimum distance requirement at #3 is

Mechanical exhaust for central supply locations shall not be more than ____.

Cryogenic fluid central supply systems up to the source valve, shall be installed in accordance with ______.

Item #4 is a ______ valve.

Factory installed outlet tubes on station inlets shall be NOT less than ____ with 0.4 inch minimum inside diameter.

A medical air proportioning system shall have a min. of __ recorders for not less than 24 hrs.

A signal from each ___ shall be connected to the master alarm to indicate a problem is present with the source equipment

Which of these components are required at the connection to an emergency oxygen supply connection (EOSC).

Gas produced by evaporation from in a bulk container system shall enter the supply ___ of the final line regulator.

Area 2 would be classified as a _________.

Which of the following filler metals shall be used to braze copper-to-copper joints in medical gas/vacuum piping?

Manifolds for gas cylinders shall actuate a(n) ___ signal and activate a indicator at all ___ alarm panels at changeover

In a non-anesthetizing Cat. 1 space, on which side of a zone valve shall the area alarm sensor be located?

Vacuum piping for ___ shall be connected separately from the medical surgical system directly to the receiver tank.

How many hours must the medical air compressor system be operating normally before air quality test can be performed?

In those portions of the system intended to handle oxygen at greater than 350 psi, the hose shall not contain ____

Which of the following conditions must be met so medical gas and vacuum systems are installed by non-certified personnel

The minimum distance requirement at #4 is

The pressure in the main line of each medical gas system, shall be monitored at the _______ alarm