Exam Revision 1

What is the most suitable piece of equipment for measuring deflection?

efficient technique to locate faults in an assembly with components in series is?

Which of the following is associated with the internal environment of an engineering company?

What is the mode of the data shown

Which of the following are reasons for using copper pipe

In the picture shown angle "a" is the?

A material that is ductile has the ability to

Which of the following employee categories has the highest vocational qualification?

In the chart below in which month where there 110 rejects

A buttress thread form has a

What is the SI unit for temperature

A 9 volt battery supply's a circuit with a resistance of 18 ohms, calculate the current flow?

Steel is heated to 925 degrees C and cooled in furnace, result of this process is?

What is the centre of an Atom called?

which of the following are causes of friction in solids?

During an appraisal the appraiser must

What is a contract of employment?

What class of material is polypropylene?

Which of the following is the correct equation to calculate a moment?

Which symbol do you use when your researching information on the internet?

Aresearch department is responsible for?

What is used to clean the protective coating of a printed circuit board PCB before soldering?

High load bearing capacity is a result of which physical property of a material?

What does CAD stand for?

The correct stages of a standard disciplinary hearing are?

Which regulation, with the Health and Safety at Work Act 1974 covers powered machinery?

What does the term subordinate indicate?

Personal Protective Equipment (PPE) should be worn

Which of the following is an operating system?

Which is the most suitable material for making a lathe bed?

Which fire extinguisher must not be used on electrical fires?

The purpose of a triangular safety sign with a yellow background is

Which picture shows a G-Clamp

Calculate the water tank capacity were the length = 700mm, width = 500mm, height = 500mm

0.45 expressed as a fraction is?

The symbol shown represents

When on site, which of the following electric hand tools is appropriate for use?

Which of the following is first angle projection?

A disadvantage of using a fax in engineering environment is?

An apprenticeship scheme is?