Cabinetmaking - NOCTI Prep #2

The plywood made from sheets of veneer attached to the outside of a piece of solid wood.

Most wooden cabinet shelves should be made of ____________ stock.

A stacked dado set used with a table saw creates a dado with beveled edges.

A very hard, dense wood , very resistant to shock, light tan colored with brown streaks.

The wood traditionally used for cutting boards is _________________.

A non-rabbeted cabinet door, mounts to outside frame, conceals opening is called _____________.

What is the name of this wood joint?

The red softwood used for lining drawers, chests, or closets is _________________.

Which hardwood plywood veneer grade with uniform color and grain, not book or slip matching.

The very expensive hardwood used for cabinets, musical instruments and gun stocks is _______.

A jointer can be used for making bevel or chamfer cuts.

The most common type of particleboard used for cabinets is ________________.

The name of this wood joint is ________________.

Aluminum oxide sandpaper is typically used to sand between finish coats.

The primary use of a radial arm saw is ______________________.

A corner joint in which a rabbet cut is made in both pieces is known as a ____________ joint.

When applying laminate to a countertop, _____________________.

All the following solid woods are normally used in high-quality cabinets except ____________.

Veneer-core plywood is composed of sheets of ___________________ glued together.

Plywood should be cut to have the grain run _______________.

A thickness planer must not be used on a board shorter than ________________.

Wood veneer is typically applied using _____________.

The wood often used as core material in plywood or for millwork, but not cabinet exteriors.

Table saws are not designed for making rabbet or miter cuts.

The name of this wood joint is _____________________.