Course 226 Test 6 EAT

5-gas analysis was a component of the later ______ testing protocol.

BMW: ____ _______ ________

4-gas analysis was a component of the earlier _______ testing procedures.

Under ASM5015 test procedures, a vehicle is operated at ______mph and under ___% load of the FTP test procedures.

A warmed-up post-catalyst O2 sensor should switch between rich and lean.

Who was largely responsible for introducing the Ford Mustang in 1964?

Evaporative Emissions monitoring is required under OBDI standardization

OBDII uses 3-digit fault codes

An ASM 2525 test operates at _______% of the maximum FTP load, and _______ mph.

SAE standardized diagnostic connectors when OBDII was introduced.

Acceleration Simulation Mode (ASM) testing uses a tailpipe analyzer and a __________.

DTCs can be designated by powertrain (P), communication (U), body (B), and ______ prefixes.

Under OBDII standardization, monitoring pre- and post-_________ is required.

The_________ test utilizes the second portion of the IM240 test from a dynomometer.

Misfire monitoring is non-continuous, while Evaporative Emissions monitoring is continuous.