Aviation Indicating and recording system

Question 1

Each altitude indicators require a single static port input.

Accepted Answer

False

Question 2

Local warning can be seen in the ECAM.

Accepted Answer

False

Question 3

Where does the Air Data Modules get its power suplly.

Accepted Answer

ADIRU

Question 4

Which display units are part of the EIS

Accepted Answer

PFD and ND

Question 5

For ADIRU equipped aircraft which component converts the pressure signal into electrical?

Accepted Answer

Air Data Module

Question 6

where is the flux valve normally located?

Accepted Answer

wing tip and stabilizer

Question 7

Master caution light can be cancelled by pressing the light cover

Accepted Answer

True

Question 8

What many display units are part of the EIS?

Accepted Answer

6

Question 9

what is the difference angle between the true and magnetic heading?

Accepted Answer

variation

Question 10

what navigation sensor/sensors is needed to compute the airspeed value?

Accepted Answer

pitot and static

Question 11

what is the indication of a level 1 alert?

Accepted Answer

amber message

Question 12

which component of the Flight Data Recorder converts the collected data to Harvard Bi phase?

Accepted Answer

Flight Data Interface Unit

Question 13

Which type of gyro is used to measure the attituce of the aircraft?

Accepted Answer

vertical gyro

Question 14

what are the indicators of the basic T

Accepted Answer

Airspeed, Altimeter, Attitude and Director and Heading.

Question 15

if the blue pushbutton light is illuminated, this means that...

Accepted Answer

temporarily used

Question 16

GPWS mode 6 provides the windshear alert to flight crew.

Accepted Answer

False

Question 17

It is the measurement of temperature of the ambient air which is normally lower than the TAT

Accepted Answer

SAT

Question 18

which type of heading indication uses the flux valve

Accepted Answer

remote reading compass

Question 19

If a large angle of attack is detected, what will be the indication in the cockpit?

Accepted Answer

Stick shaker and stall alert

Question 20

The function of the DMC 3 is to act as back up for captain display units only.

Accepted Answer

False

Question 21

Engine RPM and flight control position indicators are part of?

Accepted Answer

aircraft monitoring

Question 22

for the modern aircraft, where is the baro correction knob located?

Accepted Answer

in the EFIS control Panel

Questions 22