Shaving and facial hair design

If the last word in a stem is an, the answer must be ___________.

For a shave service, you should keep the client's skin___________.

Which of the following refers to the way the razor is held in the barber's hand to perform a stroke movement?

Observe the hair growth pattern and shave ____________it.

How many degrees relative to the skin surface should you angle the razor?

The ________ refers to the inside construction of the blade.

For a shave service, you should test the temperature of the hot towel with ______.

You should use strokes of how many inches to avoid shaving too far from the stretching point?

What is the basic question or problem in a test question called?

A beveled-edge blade usually has what type of edge?

You should use the thumb and_________ finger as the primary digits for stretching the skin.

During a shave service, you should ___________.

_________ the razor refers to a special heat treatment included in the manufacturing process.

To clean a hone, use water and __________.

Being _____________ means understanding the strategies for successful test taking.

When two responses are close or similar in a multiple choice question, ___________.

Shaving strokes on the upper lip are performed ___________.

What type of razor finish is usually the choice of the discriminating barber?

What type of stroke will you use around the mouth, over the ears, and in other tight areas?

The strop is attached to the __________ of the barber chair by a closed clip.

To open the razor, grasp the ________ of the blade between the thumb and index finger.

The razor of choice for professional barbering is the _________ razor.

In which stroke will you use a few short scooping strokes to shave upward from the top of the chin toward the lower lip?

How you hold the straight razor will depend on the ____________.

Which questions should you answer first on the written examination?

In addition to testing basic theory concepts, the written exam contains questions about your __________.

What type of hone cuts faster than the water hone?

Examination candidates should be competent in their technical skills and ready for state board ___________ exams.

The razor is stroked ________ diagonally across the hone.

Do not proceed with the service if the client has __________.

For a shave service, repeat the steaming process if the beard is ___________.

You should keep the nondominant thumb and fingertips ____for stretching purposes.

Prepare facial hair for the shave with ____________________.

Where should you discard used blades?