Quality GPSEd MSSC 32 most missed

One of your long time vendors just sent a shipment of parts without any certifications. What should you do?

Standards and specifications for conformance and inspection results are information that can be found in what documents?

You mastered a dial indicator to a 2.5" gage block. Your your first part measures 0.05” What is it's actual length?

A frequency chart is useful for what?

You notice a minor quality defect on the outside of a part that's not critical to the function. What should you do?

Corrective action reports. What information should the results section contain?

Which statement best describes a quality audit program? A quality audit program?

You found some bad parts. You segregate them and place them in a bin with a hold tag. The hold tag means what?

In reviewing a corrective action report, which area of the report will tell you if a corrective action has taken place?

Which of the following is NOT a problem analysis tool?

What are quality metrics used for?

You are investigating a problem in the shipping department. When starting your investigation what should you do?

When creating or revising standard operating procedures (SOPs), their accuracy is ensured when they are

You dropped a fixture It doesn’t look broken. It was pre-adjusted to meet a specific standard. What should you do?

What determines how often calibration on tools is performed?

The capability of a manufacturing process can be determined by using

What item is always used as a reference surface

Attribute sampling is used when doing what?

When completing a corrective action, what is the most important reason to have multiple people sign off on the document?

What is the best tool to use to torque a bolt to 2.5 ft lbs?

When should your team conduct a Design Failure Mode and Effect Analysis (DFMEA)?

You have just completed a quality check on an assembly process problem. Who should you share your data with?

You are a QA inspector looking to measure a part to an accuracy of .001 inches. What tool should you use?

Why is it important to select parts at random for sample inspection?

Would a machined bracket that measures 25.04 mm in height be in spec if the specification is 25.00 +/- .03 mm?

Proper procedures for storing data reports indicate that they should be

Pareto charts are necessary for

What is the most desirable method to evaluate a supplier?

A gage block is used to do what?

When referring to part drawings and inspections, what does the word tolerance mean? A tolerance is

The cost of preventing defects will

Control charts are necessary for what?