Cisco Routing & Switching Chapter 2

Parameter that has to be supplied by the user to an IOS command

Command to check the path that a packet takes to reach a destination

Command to verify connectivity between the source and the destination

A protocol to establish a remote secure CLI connection over the network

Which devices acts as a gateway to allow hosts to send traffic to remote IP networks?

A protocol that dynamically leases IPv4 addresses to DHCP-enabled end devices

Term that represents the operating systems used by Cisco networking devices

Parameter with a predefined value to be used by an IOS command

File that is stored in RAM and that contains the configuration that is being done on the device

Portion of operating system that interacts with applications and the user

Which command will prevent all unencrypted passwords from displaying in a config file regularly

The component of the operating software that provides the user interface is called the

File that is stored in NVRAM;has been saved on a device to be used upon startup

A user-friendly graphical environment used in an OS

What command is used to display learned IP address

A physical port of a Cisco device, aka out-of-band access

How can a route allow a router to forward packets without a specific routes destination network

To save time, IOS commands may be partially entered and then completed by pressing

What information does the ping , show ip route , and interface commands provide?

T or F? Mobile devices do not require IP addresses to communicate on the internet

A logical interface used to remotely manage a switch over an IPv4 network

Windows command that shows the IP configuration settings on a PC

Portion of operating system that interfaces directly with the computer hardware