PLTW Final Review Joe per4

What is Functional analysis?

Which of the following terms describes the minimum clearance space for maximum interference intended two mating parts?

What is a permissible amount a dimension can vary during the manufacturing of a part and have the part still be useable?

engineering tolerances are to specify the allowable variation, size of individual features,

When a group of parts are preassembled and brought to a larger group of parts in the a single unit, is referred as ____?

A Visual Analysis is ________?

What is a structural analysis?

An Iteration is a process of doing something over and over again.

Which strong view would be the most appropriate to use if an important feature of a part was too small, the total size?

Placed features such as ____ and ____ are edge treatment applied to a 3-D solid model?

In a 3-D model will a bolt go before a base plate?

calculate the volume of a rectangle prism If the H (10) L (5) W (9)?

A Trade off is...

A type of sketch involving a type of flat, orthographic front with depth lines receding at a selected angle, usually 45°

A _______ is a full size physical model that is functional and that can be tested.

____ is a step in design process that involves reassessing the designs specifications, or updating designs?

A cutting plane is needed to create which of the following views an an orthographic drawing?

A innovation is?

Work planes that are created parallel to an existing surface and a specific distance away from the surface,are referred?

One purpose of hatch marks or section marks in an orthographic drawing is to show?