Employers with employees entering a permit required confined space shall:

Have a written permit space program

Safety requirements specify that power tools must:

be fitted with guards and safety switches

Among rights related to OSHA recordkeeping, workers have the right to review:

The OSHA 300 Log and the OSHA 330A Summary

All of the following are worker rights under OSHA except for the right to:

Be compensated double their salary for overtime work

Permit-required confined spaces:

Are confined spaces that have serious health/safety hazards

The creation of OSHA provided what important right to workers?

The right to a safe and healthful workplace

Emergency exit routes are required to be well-illuminated, unobstructed and:

Equipped with a public announcement system

Which best describes the main requirements for P.I.T. operators?

Formal instruction, practical training, and evaluation

The purpose of the equipment grounding in a circuit or portable electrical equipment is to:

Protect workers from electrocution in case of a short

Which is true regarding atmospheric hazards in permit-required confined spaces?

Gases that are heavier than air may build in the lower areas

When employees are using their own PPE, the employers shall:

Ensure that PPE is adequate and properly maintained

What are 3 basic areas of machinery that need safe-guarding?

Point of operation, power transmission, other moving parts.

When the employer receives an OSHA citation, it must be:

Posted for 3 days or until violation is fixed

What is OSHA's priority of accomplishing and assigning staff resources for inspections?

Imminent danger, fatality, complaints, routine inspections

The OSHA standard on fire extinguishers:

Covers placement, use, maintenance and testing

An employer must communicate hazard information about chemicals:

At the time of the employee's initial assignment

A fire watch must be provided after welding:

For ½ hour after hot work is finished

One of the main responsibilities employers have under OSHA is to:

Provide training required by OSHA standards

The storage of oxygen and fuel-gas cylinders dictates that:

Separated by 20' or by a wall at least 5' w/ a ½ hr. rating

During an OSHA inspection:

You have the right to talk to the inspector privately

The General Duty Clause of the OSH Act may be used for citing a serious violation when:

No OSHA standard exists for the specific condition

What should you do if an insp. is needed due to hazards?

Submit a written, signed complaint with specific info.

If end attachments of a wire rope sling are cracked and deformed:

The sling must be removed from service

Lockout/Tagout devices must be:

Standardized in at least one color, shape or size

A typical OSHA inspection includes the following activities:

Inspector ID,open conference,walk around,closing conference.

studbud

OSHA 30 Final

43 termsStudBud Administration129 plays

#OSHA_30 #OSHA_1910

Flashcards43 cardsFPractice quizPHost liveL

Questions 43

Answers

1
A Safety Data Sheet (SDS) gives information about:
Injuries in the workplace
Machinery maintenance
Medical examinations
Hazardous chemicals
2
Employers with employees entering a permit required confined space shall:
Have a written permit space program
Contract independent emergency rescue services
Require all employees to be trained with fire extinguishers
Maintain clearly marked exit routes
3
The right to seek safety and health on the job without fear of punishment is spelled out in:
The General Duty Clause.
The OSHA standards
Section 11 (c) of the OSH Act
State laws
4
OSHA requires that employers pay for most required (PPE), including:
Uniforms
Logging boots
Hard hats
Weather-related gear.
5
Safety requirements specify that power tools must:
not be stored near acetylene or other flammable cylinders.
Be used within 10 ft. of their power source
not be used by more than one worker
be fitted with guards and safety switches
6
Among rights related to OSHA recordkeeping, workers have the right to review:
Medical and exposure records for all workers
All first aid treatment forms
The OSHA 300 Log and the OSHA 330A Summary
All workers compensation forms
7
All of the following are worker rights under OSHA except for the right to:
Free from retaliation for exercising safety/health rights
Know about the hazardous chemicals in their workplace
Be compensated double their salary for overtime work
A safe and healthful workplace
8
Permit-required confined spaces:
Must be manually vented because they're not naturally vented
Are confined spaces that have serious health/safety hazards
Have only one way in and one way out
Can't be entered if the air contains more than 23.5% oxygen
9
When flexible cord sets are to be used, OSHA mandates visual inspections:
Before use on any shift
Once a week
At intervals determined by on-site supervisor
As specified in the manufacturer's requirements
10
Which gloves will protect against cleaning solvents containing mineral spirits?
Nitrile Rubber
leather work gloves
Insulating Rubber
Latex Rubber
11
The creation of OSHA provided what important right to workers?
The right to privacy
The right to equal employment opportunities
The right to a safe and healthful workplace
The right to pension benefits
12
The OSHA standards for Construction and General Industry are also known as:
Construction and GI Registers
Part 1926 and Part 1910
Codes 501 through 1000
Part 1915 and Part 1917
13
Emergency exit routes are required to be well-illuminated, unobstructed and:
Equipped with a public announcement system
Clearly marked
Contain pulsating strobe lights
Ventilated with battery operated exhaust fans
14
According to machine guarding, which of these areas do NOT require guarding for protection?
In-going nip points
Rotating parts
Point of operation
Control panel
15
Which best describes the main requirements for P.I.T. operators?
Written/practical tests & qualified for fitness/eyesight
Mock scenarios w/P.I.T. incidents, test, formal instruction
Review of the OSHA standard, OJT, and practical driving
Formal instruction, practical training, and evaluation
16
If there is an open-sided floor, top rail must be how far from the floor?
36 inches
42 inches
48 inches
54 inches
17
The purpose of the equipment grounding in a circuit or portable electrical equipment is to:
Increase operating efficiency of electrical equipment
Allow tools or equipment to operate without failure
Protect workers from electrocution in case of a short
Protects from electrical faults short circuits in the tool
18
Which is true regarding atmospheric hazards in permit-required confined spaces?
As long as oxygen is above 19.5%, it's always safe to enter
Methane is toxic, has a rotten egg odor, & heavier than air.
Most hazards can be smelled. Monitoring isn't necessary
Gases that are heavier than air may build in the lower areas
19
When employees are using their own PPE, the employers shall:
Replace individual PPE at no cost to employee
Require employees to remove individually purchased PPE
Reimburse the employees
Ensure that PPE is adequate and properly maintained
20
What are 3 basic areas of machinery that need safe-guarding?
Front,back and sides of machine, material handling equipment
Brakes/trips, devices, and other moving parts
Point of operation, transmission, and control knobs
Point of operation, power transmission, other moving parts.
21
Bags of concrete stored in tiers shall be:
Kept covered with a tarp to prevent moisture damage.
Stacked against a retaining wall for extra support.
Handled by authorized personnel only.
Stacked and interlocked
22
When the employer receives an OSHA citation, it must be:
Signed and returned to OSHA
Copied and mailed to each worker
Contested and filed with the courts
Posted for 3 days or until violation is fixed
23
What is OSHA's priority of accomplishing and assigning staff resources for inspections?
Imminent danger, fatality, complaints, routine inspections
Fatality, imminent danger, routine inspections, complaints
Routine inspections, imminent danger, fatality, complaints
Complaints, imminent danger, fatality, routine inspections
24
OSHA's Safety Mgmt. of Highly Hazardous Chemicals applies includes flammables in quantities of:
100,000 lbs. or more
50,000 lbs. or more
10,000 lbs. or more
1,000 lbs. or more
25
A flight of stairs must have a standard handrail or stair rail if:
If it is and emergency escape route
If it has four or more risers.
If it is in a slippery area
It is located outside
26
A portable electric grinder may be used with the guard removed:
By a manufacturer authorized technician
When reaching into a tight space
At no point in time
Once user has been certified in the grinder's use
27
Which of these is not a type of distraction:
Cognitive Distraction
Visual Distraction
Manual Distraction
Aerial Distraction
28
The OSHA standard on fire extinguishers:
Requires total evacuation in the event of a fire
Covers placement, use, maintenance and testing
Requires all employees designated to be trained on the use
Covers only the extinguishers, which are to be used indoors
29
An employer must communicate hazard information about chemicals:
At the time of the employee's initial assignment
If a complaint is made
Any time within two weeks that an employee must use it
Before a new chemical is ordered
30
A fire watch must be provided after welding:
By the welder's helper/apprentice
For ½ hour after hot work is finished
Unless water is dumped on the work
Until lead welder gives the all clear
31
One of the main responsibilities employers have under OSHA is to:
Notify OSHA of any workplace injury or illness
Reduce air pollution in the environment
Provide training required by OSHA standards
Conduct energy audits
32
Which violations exist when an employer has an intentional disregard for safety/health?
Willful
De minimus
Repeat
Serious
33
The storage of oxygen and fuel-gas cylinders dictates that:
They may be stored together for up to one week
The cylinders should be protected by a thin coat of grease
They may be stored with combustible materials
Separated by 20' or by a wall at least 5' w/ a ½ hr. rating
34
What type of OSHA inspection is conducted when immediate death orserious harm is likely?
Imminent danger.
Complaint.
Referral.
Programmed.
35
During an OSHA inspection:
You may not describe safety/health concerns to the inspector
Employers determine which workers are interviewed
Worker reps are not permitted to accompany the inspector
You have the right to talk to the inspector privately
36
The General Duty Clause of the OSH Act may be used for citing a serious violation when:
No OSHA standard exists for the specific condition
No fatalities have occurred
Two or more employees have filed a complaint
Property damage is widespread
37
What should you do if an insp. is needed due to hazards?
Submit an unsigned complaint form to OSHA.
File a complaint online
Submit a written, signed complaint with specific info.
Request a Health Hazard Evaluation from NIOSH
38
If end attachments of a wire rope sling are cracked and deformed:
The end attachments can be replaced
The sling must be removed from service
It must be load tested
They can be repaired by a certified welder
39
Lockout/Tagout devices must be:
Standard w/red markings, indicating an approved device
Made of metal with a plastic tag
Standardized in at least one color, shape or size
Able to withstand a 20 lbs. strength test
40
Which is true regarding respirators when tight-fitting facepieces are required?
A medical exam is mandatory every year.
App D info is required to be given to the employee.
Facial hair is permitted.
Fit testing is required.
41
An employer may orally communicate their fire prevent plan if they:
Have 10 or fewer employees.
Have written permission from OSHA.
Have fire extinguishers readily available.
Comply with state and federal regulations.
42
The maximum working pressure allowed for acetylene (so that it remains stable) is:
27 psig
8 psig
25 psig
15 psig
43
A typical OSHA inspection includes the following activities:
Inspector ID,open conference,walk around,closing conference.
Inspector ID, walk around, record keeping logs,l conference.
Opening conference, programs review, walk around, citations
Records review,conference, inspection,closing conference

OSHA 30 Final Flashcards | StudBud