3 Installation Tools and Equipment

Used for base band audio and video signals; no high-def. Audio is stereo (when available.)

What is the primary difference between passive and active devices?

What is vertical clearance that must be maintained as cables pass over roadways and streets?

What direction should the P-hook face when it is installed on a house?

When cable is prepared for a connector, what needs to take place during the connector process?

What type of hook secures the aerial drop to a wooden pole?

What statement about J-hook, Q-span clamp and P-hook pieces is TRUE?

For the amplified outlets of a (ISA) Amp, 15 dB of internal gain offsets internal _____ losses.

What is the required size for RG-6 drip loops?

To weatherproof fittings at tap, use __ & apply small amount of silicone grease to port threads

How much pressure should wrench apply to fitting when tightening drop cable onto the tap port?

What is vertical clearance for Drops that pass over signs, chimneys, billboards, or antennas?

Which entry lists an acceptable reason for performing a mid-span attachment?

When should 'mobile home trailer beam clamp' hardware be used?

What condition will cause the light on top of cable line toner to illuminate?

What is the purpose of the aerial drop cable's messenger?

How can an (ISA) or other amplifier be powered when no electrical outlet is nearby?

Return level is 45 out of a 4 way. You replace 4 way with an 8 way. What is new return level?

The rubber ducky, dipole and near field probe antennas are normally used with what equipment?

Which drop cable type has a stiffer, denser jacket that better withstands being buried?

Tools used to connect drop cables to tap ports through port shields are commonly called?

-4.0 dBmV is measured out of a 2way. You replace the 2way with a 4way. What is your new level?

After new fitting is compressed, the ___ should extend about 1/16" past the end of the fitting.

Which entries list a proper location and reason for placing a splice in an aerial drop?

Which of the following make up the typical coaxial cable?

How should a drop cable's exposed wire braid appear after properly prepared for new connector?

What drops cable to use when tap is 200' from the Ground Block?

What are some of the most common sizes of coaxial drop cables?

Which entry lists another task cable locators are commonly used for?

What to do if receptacle tester reveals a wiring issue with a customer electrical outlet?

What does a negative trap do?

True or False: Do not place span clamps so that they pinch down onto the lashing wire.

True or False: It's ok to use a knife or other sharp tool to separate messenger and cable.

F-fittings on Self Install Kit coax jumpers must be__ throughout inside of customer’s premises.

If a QAM constellation on the meter shows concentrated dots in the center what does that mean?

In this meter function, statistics about one channel are shown. What is the function called?

Drop cable sag should be no more than 6" per 50' or _____ per 100'.

Which bonding solution should be selected over the others when available?

What statement about SLMs is TRUE?

This wire pulling device commonly comes in 25' lengths and longer. What is it called?

Which statement about splitter and directional coupler (DC) insertion loss is TRUE?

On meter display where left scale shows graph video/audio level. What lines mark 5dB intervals

What device is used to complete the bonding process on a galvanized conduit?

Its preferred that an Integrated Splitter Amp (ISA) does not amplify RF for which?

If you install a splitter in an attic. What would a 7/16” torque wrench be used to tighten?

Which answer accurately describes a HDMI cable?

The meter display that can show strong return path ingress spikes is known as...