T2 Final Review

All pumps for firewater systems shall be inspected for operation

The submerged lands, subsoil, and seabed known as “Federal Waters” is the

Which of the following valves are normally closed?

All automatic SSVs and FSVs are to be tested for operations and holding pressure

The detectable abnormal conditions for excess temperature in a fired component are

An normally open valve used to vent pressure from a process station on shutdown is

The lessee shall not create conditions that will pose unreasonable risk to

A document that lists components and ESS with required safety devices and lists the functions

Departing pipelines shall be equipped with a

Which of the following valves are normally open?

All pressure relief valves (PSVs) are to be tested for operation

The lessee shall maintain safety records and safety device paperwork for a period of

Formal BOEM document which clarifies or changes a regulation is

Fuel or power for firewater pump drivers shall be available for at least

What is the designation for an ultraviolet flame detector?

To determine if pollution is occurring, drilling and production facilities shall be inspected

SCSSV in a landing nipple shall be removed inspected, and repaired or adjusted and reinstalled

The maximum time allowed for a total platform shutdownupon activation of an ESD is

Piping which directs fluids between platforms or between a platform and a shore facility is a

The Safety Analysis Checklist (SAC)

In fired process components, excess temperature can be caused by

BSL and TSL shall be tested at least

The detectable abnormal condition which indicates overflow may occur is

Combustible vapors over that required for normal ignition of either the pilot or main burner is

A tubing plug shall be installed in a well if it has been shut for a period of

BDVs are required on compressor installations of

Secondary protection from gas blowby shall be provided by

The major objective of the platform safety system is to

The SDV and PSHLs on crossing pipelines shall be connected to the platform

Gas detectors (ASH) must be recalibrated and tested

API designation for relief valve

Incoming pipelines to a platform shall be equipped with

Gas blowby is defined as

The pneumatic ESD shall be tested for operation

Low pressure, low level, and backflow are detectable abnormal conditions for

Secondary protection from liquid overflow to a downstream component should be provided by the

The highest operating pressure allowable in a pipeline system during normal flow is the

Relief valves, except completely redundant relief valves, shall

The Safety Analysis Tables (SATs)

The surface controlled subsurface safety valve shall close in response to shut in signals from

A single functional piece of production equipment and associated piping is

Any method used on aplatform to collect and direct escaped hydrocarbons to a safe location is

The first letter of the functional identification of safety devices is

The highest operating pressure allowable in a component other than a pipeline is

A leak is defined as the accidental escape of ________ to the atmosphere

Liquid overflow is defined as

The purpose of the production platform safety system is to

Which agency creates reulations for oil and gas safety on the OCS

The detectable abnormal condition which indicates gas blowby may occur is

The purpose of a production platform Surface Safety System is to protect

The last character of component identification is

All pneumatic level safety highs and level safety lows shall be tested

An automatically operated wellhead valve assembly that will close upon loss of power supply is

All high pressure sensors (PSH) on pressure vessels shall

If you observe an oil spill from your facility you must immediately notify

Pressure in excess of the maximum allowable working pressure is referred to as

Written confirmation of spills shall be received by the Regional Supervisor of BSEE by

Which system measures gas

Primary protection from liquid overflow is provided by

If you see a spill from antoher rig, wh should you notify?

The major parts of the Emergency support Systems are

Subsurface Safety Valves (SSSVs) shall be installed

Each surface controlled subsurface safety device shall be tested for operation in place

PSV set pressure test tolerance for PSVs set over 70 psi is

Primary protection from gas blowby is provided by

Another name for flow safety device

An adverse occurrence in a process component which poses a threat to safety is a(n)

All pneumatic Pressure Safety Highs and Pressure Safety Lows (PSHLs) shall be tested

To protect the suction scrubber on compressor installations which safety devices are required:

Improper performance of a device that prevents completion of its design function is a(n)

Electronic PSHLs and LSHLs shall be tested

Oil spills of one barrel or more shall be reported orally to the Regional Supervisor of BSEE

Gas detection shall

What is the most important valve on a rig?

Secondary protection from the undesirable event of a small liquid leak shall be provided by

An SSV that does not operate properly or leaks, it shall be

Temperature in a process component in excess of the rated working temperature is

The lowest concentration of combustible gases in mixture with air that can be ignited at is the

Three phase separators separate

All tubing installations open to production shall be equipped with a subsurface safety device

A system of manual stations which, when activated, will initiate a platform shutdown is the

Underpressure is defined as

Any portion of a flowline that has pressure different from another portion is defined as

Shut in wells with tubing plugs are to be tested for leakage at

Safety devices on process components must be

Secondary protection from liquid overflow to the atmosphere shall be provided by

A device that operates improperly but does not prevent completion of its design function is

For what reasons can safety devices be bypassed or blocked out of service temporarily?