auto collision

The old lacquer based glazing putties are NOT recommended because

When should a paint surface receive a thorough sanding?

To cut microscopic scratches in the body to be painted, use this very or ultra fine abrasive

Tech A: too much glazing putty means a large repair. Tech B: spot putty is only for tiny hole

Which statements is LEAST likely to be true?

An acidic chemical wash that eats away any material that prevents a good primer to metal bound

Which of the following abrasives is most often used in grinding operations?

This should be used when power sanding crowned surfaces or when final sanding

Sanding prepares the surface for painting in which way?

Which of the following requires scuff sanding before refinishing

Which of the following techniques is NOT commonly used to strip paint from metal surfaces?

Which is NOT 1 of the 3 factors in deciding to apply a primer, a primer-sealer, or a promoter?

This MOST likely to describes an opening in masking material when the wrong areas get painted

Reverse masking is used to prevent

Which substance keeps paint from contacting areas that are not meant to be refinished?

Wet sanding is BEST used on

Which of the following grit sizes should be used to remove grating marks from plastic filler?

This uses two layers of masking paper to prevent bleed through or finish-dulling from solvents

When should masking be applied?

What uses hard silica sad to abrade off the old paint?

The term pot life refers to

light sand scratches in the colorcoat should be eliminated by

Scratches in the final finish can be result of

Which of the following statements is LEAST likely to be true?

This involves using fine and very fine grits of material to prep body surfaces for painting

What chemically eats into bare metal to improve pain adhesion while priming the surface

Some aftermarket panel or part suppliers protect new panels with a nonpaintable

When working with abrasives, it is important to recall each of the following EXCEPT

Which of these is NOT a good reason to use a thorough sanding process before painting?

If the old finish is weathered or scarred,

Tool to use when extreme accuracy is needed along an edge is MOST likely

A paintable primer, that is key part of the factory corrosion protection warranty on new parts

All of the following are called compounding sandpapers EXCEPT

Tech A: grinder should be used to remove paint Tech B: grinding heat can warp & thin the metal

Which of the following is NOT a step in preparing galvanized sheet metal for refinishing?

Which of the following abrasives has a sharp self-sharpening action?