Electrical Final Study Guide

Which of the following components can be bypassed with a fused jumper wire? 

The low tone horn is operational but the high tone is not. The first step to check is?

What is the first step to perform when removing an alternator?

Passenger front door lock is inoperative. Fuse is good and power is at both switches. Next?  

Inside a door there is a layer of material between the panel and door metal. This material is?

All of the following will cause higher than normal starter current draw condition except?

Using a DMM the reading is 1.03kV. The measurement is?

When testing a relay in a computer controlled circuit, you should use a/an?

Which of the following is the only way to fully restore a battery's charge?

If the left turn signal flashes faster than the right, the most likely cause is ?

When testing for a parasitic draw, the battery voltage must be at least?

While testing a charging system the voltage output should test at least?

An electrical circuit has no power at any point in the circuit. The concern is most likely?

In a parrallel circuit, the voltage drop across each branch is?

The fuel gauge displays an inaccurate reading. The most likely cause is ?

What starting component prevents an engine from starting in a gear other than PARK or NEUTRAL?

Which resource should one refer to when diagnosing a concern?

While inspecting a drive belt the tech finds the outer rib of the belt is cutoff. Most likely?

The label that contains information for engine size, emissions and spark plug gap is the?

A hot engine cranks slowly but will not start. After it cools down it starts normally. What is

The power seat is inop. the fuse is good and there is power to the switch. What's the next step

A circuit protection device is being tested on a live circuit. A uses ohmmeter B uses voltmeter

When testing an ABS wheel speed sensor while rotating the wheel, the DMM should be set at?

What is the acceptable voltage drop on a conductor in a circuit?

When performing a charging sys. output test the voltage ouput is 17.7 volts. Most likely cause?

A whining noise is heard through the speakers that changes with engine speed. Most likely cause

If the horn is inoperative, the first components to test or check are the?

The sum of all voltage drops across all loads in a series circuit will always equal?

Which of the following memory functions do you have to restore after disconnecting the battery?

A car has a SRS light flashing. The cruise is inop and the horn is inop. Most likely cause is?

Which of these are used with a heat gun to provide insulation protection for a wiring repair?

When aiming vehicle headlights, the vehicle should be parked how many feet from the wall?

A circuit in which the ampreage is the same at every point in the circuit is a?

A rear window defogger is inoperative. There is power at the grid. This means?

When testing cruise control system the cruise will not turn off unless the off button is press

To prevent starter damage when jumping a dead car, only crank the engine for a maximum of?

What is the first step to perform when removing a starter motor?

Weather-pack connectors prevent corrosion in a circuit. This prevents a an increase in?

Which of the following circuit characteristics will least likely affect resistance?

Which of these tools should you NOT use for live computer circuits? 

A wire in a wiring diagram that has the following symbol means that the wire has/is a?

While performing voltage drop tests on a charging sys. the total sys. drop should be less than?

A tech finds the insulation on a battery cable is cracked near the battery terminal. He should?

During air bag diagnostics always place the module on the bench with the air bag trim facing?

During soldering what is the process called when you apply solder to the tip of the iron?

The positive side of a circuit has continuity to a body panel screw. The circuit has?

The windshield washer is inoperative the fluid is full and the fuse is good. What's next step?

A windsheild wiper will not turn off when the switch is in the off position. What is the cause?

When the temperature of the conductor in a circuit increases, the current flow will?

When performing a battery load test a battery under a 50% CCA load should still provide?

The gauges on a vehicle are inoperative. The first step to perform is?

All IP gauges work properly with a scan tool but the speedometer does not while driving. Next?

To clean a battery use?

The most accurate method to perform a battery state of charge test is?