Cert Test

What is a handheld finishing tool that moves a continuous abrasive belt over the surface?

Why is safety important on a job site?

Which nail is typically used for light assembly work and should not be used for parts that are critical for stability?

What measurements does a framing square consist of?

Are flammable or combustible substances safe if they are tightly sealed?

 Who should try a task?

Which of the following nails have a very small, to be driven beneath the surface of the wood with a nail set?

What are router bits?

What other option is a compass used for other then making circles?

Who should know where the first aid stations are located?

What is the use for the orbital sander?

What can you do with the open end of a combination wrench?

How do you put the tape measure back in its case?

 What is special about a dual-bevel sliding compound miter saw?

Which of the following is NOT a safety concern when using a portable circular saw?

What type of wood is so hard and dense that pilot holes for nails and screws must be drilled?

What angles does the one end beveled blade of a chisel have?

Why is it important to not have too much glue around a wood joint?

Which of the following materialsismadefromthinlayersofwoodgluedtogetheratrightanglesusingpressure,heat,andbondingagents?

which nails have a flat head and are designed to cover the nail hole?

What is the blade of a block plane usually set at?

How do you use a block plane?

When using power tools, it's important to follow safety rules and take precautions. Which of the following is true?

What shapes are saber saws often used for cutting?

Which type of wood is highly resistant to decay?

What type of wood is plentiful, relatively inexpensive, and often used by carpenters?

Which following work habits do not contribute to accidents?

What is a downside of using pine wood?

which isn't a rule for handling material.?

What do accidents always result from that no one has noticed?

What do clamps do?

Which of the following provides carpenters with a quick and convenient way to determine the dimensions of an object?

Which mechanism allows the drill bits to be attached to the drill motor?

What happens to utility knife blades when they are used a lot?

Who is all responsible for recognizing hazards on the jobsite?

Why is it important to check job sites for dangers?

What do carpenters use that has threads all the way down?

What do you do with two pieces of wood that you put wood glue on if you want them fused together?

Which of the following is NOT a common drill chuck size?

Is wearing safety gear needed for most jobs?

what two sizes to speed squares come in?

 What covers the bottom part of a portable circular saw blade?