Duplicate of Design and Modeling

 A problem-solving strategy used to develop many solutions to a problem to find one solution.

In CAD, extruding an object means to:

3D (Three dimensional) means:

A perspective drawing is used to:

Which of the following things is NOT something an engineer might do?

One inch is:

What system is used to give directions to the computer to map points on the X and Y axis?

When using InventorPro, the "Home" view is always which view?

Which of the following measurement units are not part of the Standard Units of Measurement

Which of the following are elements of design?

A good definition for "Engineering" is: 

You are using 1/4in graph paper(each square=1/4 in), how many squares would be in 2 3/4 inches?

What factors should you consider when deciding what side of an object is the front?

The Acronym STEM stands for: 

What is the purpose of sketching in engineering?

In Inventor, when you move an object in a circle about a central axis, you are doing this

A quick way to get an idea onto a piece of paper is to:

Geometric constraints are restrictions applied to geometric entities include all EXCEPT:

Computer Aided Design(CAD) is:

An isometric sketch shows which of the following dimensions of the object?

You should use a decision matrix to:

A method of shared problem solving in which all members of a group generate ideas

A sketch plane is:

in Inventor you create each part separate and then put them together in which type of file?

When a line is at a right angle to another line it is said to be:

Dimensions of an object do not include:

An orthographic sketch:

When an engineer is solving a problem, it is important for them to remember:

Which of the following major countries DOES NOT use the metric system of measurement?

A dial caliper is used to measure length precisely.  It measures lengths as small as: