ASE Questions Practice test early chapters

Technician A say pull the wrench towards you, technician B says push it away from you. Who is correct?

Which type of manual or service information includes the flat-rate time and the cost of parts?

Which type of trouble light is recommended for use in the shop?

What personal information should not be included on the resume?

Early engines were called flat head design because they _____________?

Which tool has a replaceable cutting edge

Spraying accessory drive belts with a fine mist of water from a spray bottle is used to ____

Which is not recommended during an interview?

A tire is labeled 215/60RX17 92T; The T indicates _________

A service advisor is called a ______.

A vehicle with the engine in the front can be ______?

All overhead valve engines ___________.

Which of the following CANNOT be measured using a straight edge and feeler gauge?

Wetted asbestos dust is considered to be _________

An under-vehicle inspection includes checking for _______

When inspecting engine oil, what should be checked?

What type of socket should be used with an air impact wrench?

One of the deductions from a paycheck is for Social Security. This item is usually shown on the paystub as _______?

ASE Tests require knowledge of vehicle certifications for spark plug gap.

Which type of diesel injection produces less noise?

Normal oil pump pressure in an engine is _____________ ?

The part of the tire that is just under the thread of a radial tire is called the ______

When working with hand tools, always ______________?

Gasoline should be stored in approved containers that include what color(s)?

Wiring diagrams are usually found where?

All safety glasses should meet the standards set by __________?

To check a crankshaft journal for out of round, the journal should be measured in at least how many locations?

Which diesel system supplies high-pressure diesel fuel to all the injectors all the time?

Before lowering the vehicle, what should the technician do?

The tenth character represents the year of the vehicle. If the tenth character is a Y, what year is the vehicle?

What type of pliers is capable of fitting over a large object?

Which type of question is the same as two True and False type questions?

Which metric unit of measure is used for volume measurement?

The vehicle identification number (VIN) since 1981, is how many characters long?

Which description best fits the role of a service advisor?

When using a fire extinguisher, what word can be used to remember what to do?

Housekeeping duties of a technician can include ______________

When checking for stability, how high should the vehicle be raised?

All of the following are usual duties of a lube technician except _____?

A four-wheel drive vehicle often uses a ________ to transmit torque to all four wheels?

If coolant is mixed 50-50 with water, what is the freezing point?

A type of test question not asked on the ASE Certification is __________

A coolant leak will show as what color?

Component Location can be found in _________

An engine is operating at 2,000 RPM’s while the vehicle is traveling down the highway. The oil pressure should be about

What part of an engine is considered to be the foundation of the engine?

Dextron VI and Mercon V are examples of ________

A V-type engine could have how many cylinders?

A bolt threaded into a casting is often called a _________?

Used engine oil should be disposed of by all EXCEPT the following methods:

Type of communications include

What is the fluid called that has to be refilled regularly if the diesel engine is equipped the SCR?

A red fluid is discovered under a vehicle. This could be due to a leaking _______

Professionalism includes which factor?

Horsepower is ___________?

When using compressed air and a blow gun, what is the maximum allowable air pressure?

What type of fastener is commonly used to retain interior door panels?

Pad extensions may be needed when hoisting what type of vehicle?

The grade of a fastener, such as a bolt, is a measure of its ________

Using modified X tire rotation method on a front-wheel-drive vehicle, where would be the place for the right front tire