Enginering Concepts Course Review

When designing a bridge, civil Engineers must consider which of the following?

Stress divided by strain results in the ________________.

When engineers strive to achieve maximum efficiency and it gives the perfect solution.

What is a product specification?

A(n) __________ drawing shows parts in their proper places and how they fit together.

In order to select the best possible solution, all of the possible solutions must be _________.

During the 1800s, a technician would have been called a(n)

Genetic engineering involves ________

The best way to test a solution is to

A tendency for a material to be pulled apart is _________________.

A force that has both a magnitude and a direction.

The Earth is pulling on an object with force mg, What is the reaction force?

Which type of worker would be most likely to use schematic diagrams

Principles of design that most directly affect appearance include

In the design process, the step after building a prototype is typically

To resist a load, an structure must push back with a force that is equal and _________?

________ capabilities allow a designer to be surrounded by an image that changes as he turns.

Brainstorming is one way to promote

What organization sets and enforces protective workplace safety and health standards?

The pointon a load deformation curve where the material snaps is called the _________ point.

___________ is the property of returning to an initial form or state following deformation.

A full size, working model of an object (Usually the first one made) is called what?

The CTSO that is available for students in the Engineering programs in GA is called what?

Flat plates that are used to strengthen the connection between members in a trussbridge.

A non-working, 3D model of a proposed product is a ________?

Forces that try to make material tear and slide by each other are ___________.

Analyzing a prototype to see if it works as predicted is called ________.

Which is NOT a step in the problem solving process?

Amount of elongation of a member divided by the member’s original length.

When conducting engineering tests, data that CANNOT be measured in units is called_____.

When conducting engineering tests, data that CAN be measured in units is called ________.

Design portfolios, design journals, sketches, and schematics are all used to do what?

Materials that continue to stretch are called ____________.

A(n) _________ designs structures.

A(n) ________ is a force that is applied to a structure.

Which of the following is an example of a career related to the transportation industry?

Materials that do not stretch or have NO elasticity are said to be __________.

In technology, adapting means

__________ is the maximum tension force a mamber can carry before it fails.

The permanent elongation of a member is called _______________ deformation.

According to Newton’s 1st law of motion, with no external force, a moving object will

ASME is the ________.

A force that has a magnitude but DOES NOT have a direction

Any engineer’s primary focus should be what?

Engineers are concerned with ________?

The purpose of a simulation is to ____________________.

The most far reaching standards organization is the _________________________.

Designing a mouse for a computer to fit well in your had would demonstrate

The letter “S” in OSHA stands for _________________.

If you are brainstorming, you are _____________________.

The SI unit for a force is?

The third course in the engineering pathway is.

Rapid prototyping relies on

Forces that twist or bend a material are called ________________.

Civil engineers may work on any of the following EXCEPT

The Galloping Girdie was which of these famous bridges?

It is the ________ who decides from what materials a product will be made.

The tensile force placed on a member divided by the cross-sectional area is known as what?

A force that has both a magnitude and a direction.

Ergonomics involves _________?

The IEEE is the professional organization for what group?