Quiz #7 in EE-IPC 425

How many voltages are available for a three-wire DC distribution system?

According to Buller and Woodrow, for equivalent hours loss factor, the value of a for rural areas is equal to

Which of the following distribution systems offers the best economic advantage at high voltages?

Feeders are designed mainly from the point of view of its ____

___ refers to leveling out peak electricity use by power consumers in the industrial and commercial sectors.

What is the permissible limit of voltage variations allowed in distribution systems in the Philippines?

Which distribution system is energized by two or more generating stations or substations?

FIT-ALL is an additional tariff imposed on consumers of electric power which means ____.

Which type of distribution is preferred in residential areas?

The cable that connects the distributor to the consumer terminals is called as ___ lines

THD means:

Of the components in the grid which is characterized as the most unglamorous component?

A radial power system is represented by _______

The ratio of Active Power to Apparent Power.

Which of the following is NOT a unit of electricity demand?

The condition of an Equipment when it is de-energized or disconnected from the System.

Any person or entity authorized by the ERC to sell, broker, market, or aggregate electricity to the End-Users.

Which component connects the substation to the area where power is to be distributed?

The deviation of the root-mean-square (RMS) value of the voltage from its nominal value, expressed in percent.

This is the only portion of your electricity bill that goes to the distribution utility.

TDD means:

A voltage level exceeding 1 kV up to 34.5 kV.

A ___ elbow requires the cable to be dead in order to be detached or attached and is typicallyrated for 600 A.

An entity or an electrical equipment that consumes or draws electrical energy.

Referred to as the identification and separation of the individual cost for providing each electric service to consumers