Med gas quiz 10 part 1

Area alarms shall be tested to verify the warning signals for all vital life support and critical care areas if the

Persons maintaining medical gas and vacuum systems shall have appropriate qualification by demonstrated one of the…

Instrument air sources shall produce air at not less than a gauge pressure of___.

Breached portions of the systems subject to inspection and testing shall be confined to only the specific altered zone

Instrument air systems shall activate the alarm systems when the dew point at system pressure exceeds___.

The 24 hour standing pressure test shall be witnessed by the AHJ or its____.

Inspection and testing shall be performed on all new piped gas systems, additions, renovations, temporary installation

In category 2 piped gas or piped vacuum systems shall be permitted to administrate moderate sedation, minimal sedation

During the initial pressure test, the source shutoff valve shall remain closed and the test pressure for pressure gases

Intake air for instrument air compressors shall be permitted to be drawn from what location?

Final line filters for instrument air shall be rated for a minimum___efficiency at___micron.

Installer shall create a form indicating that the standing pressure test has been performed and witnessed, a copy shall

Before the piping system is put into use, who is responsible for the ascertaining that the gas delivered to outlet/inlet

Alarm panels and shutoff valves labeling shall be__when modifications are made, changing the areas serviced.

At the sample port a demand of approximated 25% percent load shall be created to cause the compressors to cycle on

After a final tie-In on an active vacuum system, each vacuum joints shall be tested with a__leak detector or other means

After the piping system, blow down test shall be done. Then the Installer must perform which of the following test?

The air quality tests shall be conducted after the medical air source system has been operation normally, but with the

Instrument Air system that employ a standby header shall be permitted to have a simplex cooler and dryer. Where a

Medical air purity for compressor systems shall be analyzed prior to the source valve being opened. Samples taken at the

Nitrogen and instrument air supply systems are not to be used for patient care, but are used for powering pneumatic

After the final Tie-in each joint shall be leak tested by the source gas. New work and the existing system at the normal

Distribution piping for support gas systems(nitrogen and instrument air) shall be__type “L” copper tube.

Initial piping purge test the installer shall use the appropriate adapters and purge with an intermittent high volume

Support gases system are subject to the same hazards as, present in any piped medical gas system with additional hazard