UNIT - II QUIZ

21. The figure represents _______ bit microprocessor

In adaptive control with constraints system the spindle speed and feed rate are

4. The basics of many signal conditioning modules is

24. Voltage gain of inverting amplifier is

11.     Microcontroller has ___________ no of bit handling instructions

25. The below figure is ___________ type of multiplxer

5. The non-linear output from the sensors is linearised with

2. Microprocessor is the _________ of the computer and it perform all the computational tasks

3. The purpose of the microprocessor is to control __________

8.     The applications of multiplxer are

16. Digital logic control is a system works on the principle of

9.     Device with one input and multiple output lines is

13.     Adaptive control has the applications in the field of

7. Multiplexer is a device that has multiple input and

15.     Address bus and control bus are a

14.     A register in a microcontroller is a

1.     The process of amplifying the output signal from the sensor to suitable signal for next stage of the operation is

12.     Adaptive control is basically a

10.     Connection lines, used to connect the internal parts of the microprocessor chip is called

17. Geometric adaptive control is used in ________ machining operations

6. Analogue-to-digital conversion involves converting analogue signals into

23. In the below pin configuration 4 represents

22. In the 2 represents ________ pin configuration

20. Arithmetic and Logic unit performs _______ operations

19. In milling and turning operations, the worktable position and velocity can be determined by counting the