Design and Modeling

In Inventor, when you move an object in a circle about a central axis, you are doing this

You should use a decision matrix to:

What factors should you consider when deciding what side of an object is the front?

The Acronym STEM stands for: 

In CAD, extruding an object means to:

A method of shared problem solving in which all members of a group generate ideas

You are using 1/4in graph paper(each square=1/4 in), how many squares would be in 2 3/4 inches?

A good definition for "Engineering" is: 

An orthographic sketch:

When an engineer is solving a problem, it is important for them to remember:

Which of the following measurement units are not part of the Standard Units of Measurement

One inch is:

When a line is at a right angle to another line it is said to be:

Computer Aided Design(CAD) is:

Dimensions of an object do not include:

A sketch plane is:

An isometric sketch shows which of the following dimensions of the object?

Which of the following things is NOT something an engineer might do?

A dial caliper is used to measure length precisely.  It measures lengths as small as:

in Inventor you create each part separate and then put them together in which type of file?

A quick way to get an idea onto a piece of paper is to:

What system is used to give directions to the computer to map points on the X and Y axis?

Geometric constraints are restrictions applied to geometric entities include all EXCEPT:

Which of the following major countries DOES NOT use the metric system of measurement?

When using InventorPro, the "Home" view is always which view?

What is the purpose of sketching in engineering?

Which of the following are elements of design?

A perspective drawing is used to:

3D (Three dimensional) means:

 A problem-solving strategy used to develop many solutions to a problem to find one solution.