Safety Saturday 2025

What is the primary purpose of hearing protection on a construction site?

What type of accidents lead to the most annual Construction deaths?

What is a Safety toolbox talk?

An employee working in a scissor lift that needs to exit the platform while elevated, what must they have

 What is Construction’s “Fatal Four” accidents?

A toe board shall be erected along the edge of platforms more than 10 feet above lower levels?

As per fire theory, fire needs four elements to start: heat, fuel, oxygen and _______?

Sugar is good at fighting fatigue?

Identify the tool that is most frequently the source of disabling injuries than any other hand tool:

What is the purpose of an "emergency evacuation plan" on a construction site?

Which of these is not an effect of fatigue?

15lbs. is the maximum force allowed for an automatic door to exert?

A chute must be used when the drop height exceeds...?

The most crucial time in saving a life after an accident or emergency is “The first 4 minutes”

What is the primary purpose of a safety data sheet (SDS) on a construction site?

What is the most common injury caused by improper lifting techniques?

Ladders must extend 3 feet above the landing?

The purpose of "emergency eyewash stations" on a construction site is to clean your safety glasses?

General contractors may not EXCEED OSHA minimum requirements?

How long does an employer have to notify OSHA when a fatality occurs?

Name the form that summarizes the previous year’s work-related injuries/illnesses that must be posted From Feb. - April?

What is the purpose of a riving knife?

A hook/ball on a crane is called a _______________ as it can cause significant injury or death?

Where did NCE rank in nation for the 2024 ENR Top 600 Specialty Contractor for Wall and Ceilings?

What is the primary use of a Job Hazard Analysis (JHA)?

What does AAADM stand for?

In an electrical fire, which types of fire extinguishers are most preferred?

Which type of safety device should be placed ALL exposed re-rod to protect workers from impalement?

It's acceptable to work on a construction site without wearing any PPE if you are only performing a quick task?

What is the primary purpose of a "hot work permit" on a construction site?

Electrical shock can cause?

In order to have two monitored safety devices on an overhead door, what additional component must you have?

Where did NCE rank in nation for the 2024 ENR Top 600 Specialty Contractor for Glazing and Curtain Wall?

What does the acronym "HAZWOPER" stand for in construction safety?

What must be on the face of all vertically stacked dry wall against the wall?

Eye wash solution is primarily made up of...?

Who is responsible for hand and power tool safety?

Which class of hard hats can save you from high voltage shocks as well as provide penetration and impact resistance?

What does the acronym "LOTO" mean?

Scaffold components must be able to support Its own weight, plus _____ times the maximum intended load without failure:

"Flash point" is defined as the highest temperature at which vapor produced by a liquid that when ignited will flash

During air monitoring to determine safety limits, all the chemicals listed are common hazards with the exception to one?

What is the purpose of a "toolbox talk" or safety meeting on a construction site?

W&G is the abbreviation for?

What type of fire extinguisher is suitable for extinguishing electrical fires on a construction site?

Storage of LP gas cylinder must be?

It's okay to disable or remove the machine guards on a power tool if they are slowing you down and getting in your way?

The responsibility of fire prevention belongs to?

What is the most commonly used safety device for Overhead Doors?

What 2 categories of people can use a woodworking machine?

A powder-actuated tool should not function until it is pressed/pushed against the work surface with a minimum force of?

A toe board must be at least __ inches higher than the walking surface?

Automatic doors should be inspected and tested by an AAADM Certified Technician every year?

Welding Shields primarily protect against?

What mark appears on the frame of industrial quality safety glasses?