Enginering Concepts - Fall 2016

A(n) _________ designs structures.

Designing a mouse for a computer to fit well in your had would demonstrate

Engineers are concerned with ________?

The letter “S” in OSHA stands for _________________.

___________ is the property of returning to an initial form or state following deformation.

The third course in the engineering pathway is.

Flat plates that are used to strengthen the connection between members in a trussbridge.

A(n) __________ drawing shows parts in their proper places and how they fit together.

Amount of elongation of a member divided by the member’s original length.

Rapid prototyping relies on

The pointon a load deformation curve where the material snaps is called the _________ point.

The best way to test a solution is to

The Earth is pulling on an object with force mg, What is the reaction force?

The most far reaching standards organization is the _________________________.

Which of the following is an example of a career related to the transportation industry?

Analyzing a prototype to see if it works as predicted is called ________.

Forces that twist or bend a material are called ________________.

ASME is the ________.

In order to select the best possible solution, all of the possible solutions must be _________.

What is a product specification?

Civil engineers may work on any of the following EXCEPT

The CTSO that is available for students in the Engineering programs in GA is called what?

Ergonomics involves _________?

Genetic engineering involves ________

The permanent elongation of a member is called _______________ deformation.

According to Newton’s 1st law of motion, with no external force, a moving object will

When conducting engineering tests, data that CAN be measured in units is called ________.

A non-working, 3D model of a proposed product is a ________?

When conducting engineering tests, data that CANNOT be measured in units is called_____.

Forces that try to make material tear and slide by each other are ___________.

Any engineer’s primary focus should be what?

________ capabilities allow a designer to be surrounded by an image that changes as he turns.

A tendency for a material to be pulled apart is _________________.

In technology, adapting means

The Galloping Girdie was which of these famous bridges?

Stress divided by strain results in the ________________.

In the design process, the step after building a prototype is typically

Principles of design that most directly affect appearance include

A(n) ________ is a force that is applied to a structure.

It is the ________ who decides from what materials a product will be made.

When designing a bridge, civil Engineers must consider which of the following?

Materials that continue to stretch are called ____________.

The IEEE is the professional organization for what group?

A full size, working model of an object (Usually the first one made) is called what?

During the 1800s, a technician would have been called a(n)

__________ is the maximum tension force a mamber can carry before it fails.

The tensile force placed on a member divided by the cross-sectional area is known as what?

A force that has a magnitude but DOES NOT have a direction

To resist a load, an structure must push back with a force that is equal and _________?

The SI unit for a force is?

Which type of worker would be most likely to use schematic diagrams

Materials that do not stretch or have NO elasticity are said to be __________.

When engineers strive to achieve maximum efficiency and it gives the perfect solution.

A force that has both a magnitude and a direction.

Which is NOT a step in the problem solving process?

If you are brainstorming, you are _____________________.

What organization sets and enforces protective workplace safety and health standards?

Brainstorming is one way to promote

The purpose of a simulation is to ____________________.

Design portfolios, design journals, sketches, and schematics are all used to do what?