Duplicate of Safety Module- Trade Terms Quiz-BBCTA

Question 1

A(n) ______ has proven their extensive knowledge, training and experience.

Accepted Answer

qualified person

Question 2

a good _____ helps to prevent or correct conditions that can cause accidents.

Accepted Answer

management system

Question 3

an opening in a wall or floor is a safety hazard and must be either _____ or covered.

Accepted Answer

guarded

Question 4

Agency created to save lives, prevent injuries and protect the health of America's workers

Accepted Answer

OSHA

Question 5

Never look at the _____ caused by welding without proper eye protection.

Accepted Answer

arc

Question 6

When doing _____, you must be careful not to come into contact with the hazard.

Accepted Answer

proximity work

Question 7

houses the circuits that distribute electricity throughout a structure

Accepted Answer

electrical distribution panel

Question 8

to prevent a cave-in, follow OSHA regulations for ______ up a trench.

Accepted Answer

shoring

Question 9

Overloading, which means exceeding the ________ of a ladder, can cause ladder failure.

Accepted Answer

maximum intended load

Question 10

OSHA rule requiring all contractors to educate employees about the hazardous chemicals at work

Accepted Answer

HazCom

Question 11

large enough for work, but limited entry or exit; sometimes a permit is required

Accepted Answer

confined space

Question 12

SCBA is an example of a(n) _____; the assembly of machines to do a job.

Accepted Answer

apparatus

Question 13

identifies unsanitary, hazardous or dangerous working conditions and the authority to correct

Accepted Answer

competent

Question 14

the unit of measure for the illuminating light on a surface, equal to one lumen per square foot

Accepted Answer

foot-candle

Question 15

the connection between electrical equipment or circuit and the Earth

Accepted Answer

Ground

Question 16

This non-adjustable ladder has two rails, rungs between rails, and safety feet at the bottom

Accepted Answer

straight

Question 17

The box for switches used to regulate and distribute electricity in a building

Accepted Answer

switch enclosure

Question 18

a device that interupts & de-energizes a circuit to protect from electrocution

Accepted Answer

ground fault interrupt circuit

Question 19

a man-made cut, cavity, trench, or depression in an earth surface, formed by removing earth

Accepted Answer

excavation

Question 20

on scaffolding over 10 feet, use _____ , diagonal from bottom to top of another rail to support

Accepted Answer

cross-bracing

Question 21

a chip or fragment of rock or soil that has broken off from the main mass

Accepted Answer

spall

Question 22

two straight ladders connected so the length can be adjusted

Accepted Answer

extension ladder

Question 23

Refer to the _____ to learn about how to handle hazardous substances.

Accepted Answer

MSDS

Question 24

before working in a(n) ______ you must be trained, have a permit, and take necessary precaution

Accepted Answer

confined space

Question 25

If a work area has been _____; it has material at least 2" thick and 6" wide for flooring

Accepted Answer

planked

Question 26

if welding/cutting fuel/gas is improperly mixed, it can cause a(n) _______.

Accepted Answer

flash burn

Question 27

If you are operating a vehicle on a jobsite and cannot see your rear, get a(n) _____ to direct

Accepted Answer

signaler

Question 28

use only approved _____ for electrical plugs

Accepted Answer

concealed receptacles

Question 29

a narrow excavation or _____ ;below ground, generally deeper than it is wide.

Accepted Answer

trench

Question 30

the process of joining metal pieces by fusion

Accepted Answer

arc welding

Question 31

When working 6' or more above ground, your harness must have a(n) ____ attached to an anchor.

Accepted Answer

lanyard

Question 32

the horizontal member at the top of all scaffolding & platform work spaces

Accepted Answer

top rail

Question 33

store _____ liquids in safety cans to avoid the risk of fire

Accepted Answer

flammable

Question 34

The _____ on a scaffold is placed halfway between the toe board and the top rail.

Accepted Answer

top rail

Question 35

When fuel reaches the _____ temperature to emit enough gases to burn

Accepted Answer

flash point

Question 36

A(n) _____ tells you which way the wind is blowing

Accepted Answer

wind sock

Question 37

a(n) _____ is caused from even a brief exposure to the ultraviolet light from arc welding.

Accepted Answer

flash burn

Question 38

The general construction rule that states fall protection is required any time you are 6' above

Accepted Answer

six foot rule

Question 39

because _______ materials catch fire and burn easily; remove them regularly from the work area.

Accepted Answer

combustible

Question 40

When climbing a ladder or scaffold, use a _____ or tagline to pull up your tools.

Accepted Answer

hand line

Question 41

Manufactured and rolling are two basic types of _____.

Accepted Answer

scaffolding

Question 42

The ______ provides clean air for breathing in a SCBA

Accepted Answer

respirator

Question 43

_____ for welding includes: a face shield, ear plugs, and long, heavy gloves

Accepted Answer

PPE

Question 44

Set up a proctective ______ when welding with other workers present

Accepted Answer

welding screen

Question 45

The _____ is the waste material from welding operations

Accepted Answer

slag

Question 46

a formal procedure for taking equipment out of service and ensuring it cannot be operated.

Accepted Answer

Lockout/Tagout

Question 47

A vertical barrier called a(n) _____ is used on scaffolds to prevent falling tools & materials

Accepted Answer

toe board

Question 48

While welding, wear _____ to protect your eyes from the _____.

Accepted Answer

flash goggles, flash

Question 49

the flame cutting process results in oxides that mix with molten iron and produce ______

Accepted Answer

dross

Question 50

which ladder is self-supporting with two sections hinged at the top

Accepted Answer

step

Duplicate of Safety Module- Trade Terms Quiz-BBCTA

Questions 50

Duplicate of Safety Module- Trade Terms Quiz-BBCTA

Questions 50