IED EoC Exam Review

Calculate the surface area of the object. Round to the nearest hundredth of a square inch.

What type of tolerance is shown?

Mass per unit volume is known as

What is the minimum number of views necessary to fully describe the part shown?

The icons pictured are used to define the shape and size of a sketch are called:

What type of pictorial is this?

Generating a large quantity of ideas for a solution to a problem is called?

Which line of sight is the best choice to use for the front view orthographic projection?

Which phrase does NOT apply to brainstorming?

The common method of communicating the size and shape of a object intended for manufacture is

A foam material has a density of 175 g/L. What is its density in units of lb/ft3?

What are the part indicators in this drawing called?

Which information is necessary to locate a hole's position in an orthographic projection?

An improvement of an existing technological product, system, or method is refereed to as

Figuring out how a device functions is called

Answer the question below

Which is the first view placed or created in a 3 view drawing or sketch?

Which term best describes the guidelines, protocols and rules of conduct design teams develop?

The most common views used in a three view orthographic projection are:

What type of drawing best describes this image?

Answer the question below

Volume, mass, center of gravity, and density are examples of which of the following?

The page shown in the diagram is most likely taken from a(n):

Extension line gap, precision, units, trailing zeros etc are options in the

A sketch with text added to enhance the communication of the ideas/thoughts of the designer is:

This image is an example of a(n)?

Which element will enhance the visual appearance of a 3-D sketch?

The dialog box below is

Which type of line does the arrow indicate?

What type of pictorial is this?

Answer the question below

The steps in the image are what method of making a part?

The callout is for what type of hole?

The basic dimension on a detail drawing that indicates the distance from the front to the back 

The first part brought into an assembly is known as the base component.  The base component is

What is the item pictured?

The final step in this drawing was:

This image is an example of what type of pictorial drawing?

Entries in an engineering notebook should always be in

Answer the question below

Which label best describes the list of requirements?

Never dimension to a(n):

The bench pictured is an example of what Principle of Design?

Parallel, tangent, and coincident are examples of which of the following?

Engineers create these to quickly record, communicate, and investigate ideas.

What type of drawing view is this?

To convert quarts to gallons what conversion factor would be used?

How many degrees of freedom remain if an ungrounded part has a single insert constraint ?

What is the item pictured?

The front view of a part is shown above. What is the tolerance on the hole diameter?

Answer the Question below

Answer the question below

100 parts need to be painted, what physical property is used calculate how much paint to buy?

If all the dimensions on a part have the same precision, which would cost more to machine?

The organization that sets the standards for drawing symbols, line conventions, & dimensions  

IFa small assembly is created and brought into a larger assembly.  The small assembly is a

The precision measuring tool pictures is called a(n)?

Close, loose, and normal are options that can be selected when creating what kind of hole?

Answer The question below

The images pictured are best described as:

What type of hole should be modeled if the hole is to have a bolt tightened into it?

How many degrees of freedom does any unconstrained object have in 3-D modeling?