Preventative Maintenance Post-Test Review

Each end of the I-beam has a device that connects the front wheels to the suspension called a

Some movement of the brake ___________ should be present on all disc brakes.

Broken and loose alternator mounting may indicate damage from which of the following?

Tech A- no free play on a pull-type clutch can cause wear. Tech B- hydraulic clutches operate without release clearance.

Regular PM ensures maximum ___________ when trading a vehicle for a replacement.

Chassis lubricants are greases classified in terms of their ___________.

Tech A- PMI process begins with a walk-around inspection. Tech B- you should perform the walk-around inspection alone.

Tech A- truck air brake systems usually have primary and secondary tanks. Tech B- air brake systems use air dryers.

Tech A- the PMI process begins with a walk-around inspection. Tech B- you should perform the walk-around alone.

A(n) ______ belt is a type of multi-rib belt that is long enough to drive multiple accessories.

A ____________ should include an itemized task list of procedures.

Engine-on inspection, start the vehicle and let it idle for a few minutes to check for _______.

Tech A-steering knuckle enables the turning of the wheel end. Tech B-steering knuckle connected to I-beam by master pin.

All wheel nuts must be tightened to the correct torque and in the proper

Tech A says the treadle valve is used for the rear brakes. Tech B says the treadle valve is used for the front brakes.

Low beams and high beams may operate together when the high beams are_____________.

Tech A-you should check all exterior lights, lenses, covers. Tech B- you should check any visible wiring for condition.

A lockout/tagout is an umbrella term that describes a set of safety _______________.

The process air dryers use to trap oil and water from the compressor in a replaceable cartridge

Type of tire that air is sealed inside using an inner tube separate from the tire casing.

If a clutch does not release completely, the cause may be _________________.

Tech A says use a safety cage to inflate a tire. Tech B says dismount a tire before inflating.

Pulling of a vehicle to the left or the right while the driving may be caused by what?

Any vehicle operating on public roads and highways requires a _________ system.

Bazooka tubes are used to_________________________.

The most common cause of wheel seal leaks is loose wheel________.

Tech A-wheel alignment refers to vehicle tires. Tech B-rolling resistance & wheel alignment is not an issue of fuel use.

Generally, lamps facing frontward must emit what color light?

If a fifth wheel lock is closed, what would you check?

Braking odors are typically related to overheated____________.

Brake fluid that is hygroscopic means it______________.

The distance between the centerline of front and rear axle or tandem suspension is called the _______________.

Complaint for air systems is that have a slow pressure build-up, the cause could be what?

Oils are graded or classified by the American Society of Automotive Engineers (SAE) through the

Safety legislation defines a CMV as a vehicle that is used for interstate commerce business and

If the electrolyte level is lost through evaporation, what should be added?

Fifth wheel and upper coupler inspection is recommended every three months, or _______ miles.

Most of today's truck suspension systems use what type of mounting bushings?

A vehicle _________ raises a whole vehicle off the ground to easily work on the underside.

What component would this complaint apply? Won't pass air to unloader to “cut-off ” compressor.

What could cause the ribs in the middle of the tire wear faster than those on each side?

If the solenoid clicks or chatters, it might indicate that there is (are) _________________.

A life requirement for a heavy duty diesel engine would be how many miles?

Tech A- tires lead all roadside breakdowns. Tech B- tires are 2nd most common source of defects leading to accidents.

After bleeding the hydraulic clutch, what type of fluid do you fill the master cylinder with?

Brake drums need to be discarded if they experience__________________.

How often should air tanks be drained?

Oils with low viscosity ratings are for what type of conditions?

The maximum tire pressure is located on the tire _________.

An alternator loose belt will slip and cause