Carpentry I Review

Wooden joists are normally placed ______ OC with the crown ______

Which Marathon should Mr. Burrows first?

What is the pitch of the roof?

For a building where siding will be installed what is the minimum sheathing thickness?

This nail is commonly used for?

Which grade of hardboard can be used in exterior applications?

When constructing a non load bearing steel stud wall what determines the spacing?

Number of 16' lumber are needed for sole, top and double top plates for a 35' x 45' building?

What type of masonry anchor is set into wet concrete?

Hand saw for rough cutting access holes and electrical boxes is called a _____________

The tool shown is a ____________________

The term S-dry on a lumber grade stamp means the lumber constains ___________ moisture.

The width for a header rough opening is usually equal to the width of the?

The image is a _________?

Solid bridging should be installed at intervals no greater than ?

When doing a quantity take off the last step is to ___________

The framing member that goes between a sill and sole plate is ?

When looking for the quality of materals and methods of construction you would refer to the?

What will be the biggest factor influencing Callie's college choice?

What type of clamp is commonly used to secure round, oval and oddly shaped work?

The type of adhesive that is applied with a dual-cartridge applicator is _______?

The symbol below is for ?

Which of the following would show the location of openings for stairways?

Iron tools such as saws, hatchets and rasps have been available for about ___________ years.

The concrete below is ______________ 

Steel bars that are bonded within concrete to increase its strength are ____________

The arrow is pointing to ?

The minimum amount of on the job training required in an apprenticeship program is?

The orange framing member is referred to as a ?

Sills are normally made from what size lumber?

Type of construction where each floor is built as an individual unit is ____________ framing

Which is commonly done with a power stapler and not a power nailer?

A type of cut often made with a circular saw is called a ?

What will be the biggest factor in Mark's decision on which Frat to join?

The dimensions for a window marked "3048" are ?

What size nails are used to fasten joists to joist headers?

What is the approximate length of a 20-penny nail?

Green concrete is so named because of its ____________

Light framing lumber is classified as ?

Lumber inspection criteria is defined by _______________?

Who would win in a spelling bee?

The edge in the image is known as a ___________ cut.

The purpose of form sheathing is to _____________

When installing plywood subflooring, you should nail along the edge every ____?

If Callie and Mark arm wrestled, who would win?

A bolt with an oval, unslotted head is called a _________________ bolt.

What is the main function of a router?

When looking for quality of materials and methods of construction you would refer to?

The dimensions of a typical concrete block is?

Which drawing shows the location of the floor openings for stairways?