Safety Module- Trade Terms Quiz-BBCTA

The box for switches used to regulate and distribute electricity in a building

if welding/cutting fuel/gas is improperly mixed, it can cause a(n) _______.

store _____ liquids in safety cans to avoid the risk of fire

because _______ materials catch fire and burn easily; remove them regularly from the work area.

When climbing a ladder or scaffold, use a _____ or tagline to pull up your tools.

Agency created to save lives, prevent injuries and protect the health of America's workers

When doing _____, you must be careful not to come into contact with the hazard.

When fuel reaches the _____ temperature to emit enough gases to burn

use only approved _____ for electrical plugs

This non-adjustable ladder has two rails, rungs between rails, and safety feet at the bottom

The ______ provides clean air for breathing in a SCBA

While welding, wear _____ to protect your eyes from the _____.

A(n) ______ has proven their extensive knowledge, training and experience.

Manufactured and rolling are two basic types of _____.

before working in a(n) ______ you must be trained, have a permit, and take necessary precaution

SCBA is an example of a(n) _____; the assembly of machines to do a job.

A vertical barrier called a(n) _____ is used on scaffolds to prevent falling tools & materials

The _____ on a scaffold is placed halfway between the toe board and the top rail.

_____ for welding includes: a face shield, ear plugs, and long, heavy gloves

The general construction rule that states fall protection is required any time you are 6' above

Never look at the _____ caused by welding without proper eye protection.

Refer to the _____ to learn about how to handle hazardous substances.

Overloading, which means exceeding the ________ of a ladder, can cause ladder failure.

If you are operating a vehicle on a jobsite and cannot see your rear, get a(n) _____ to direct

an opening in a wall or floor is a safety hazard and must be either _____ or covered.

A(n) _____ tells you which way the wind is blowing

the unit of measure for the illuminating light on a surface, equal to one lumen per square foot

The _____ is the waste material from welding operations

the horizontal member at the top of all scaffolding & platform work spaces

the process of joining metal pieces by fusion

identifies unsanitary, hazardous or dangerous working conditions and the authority to correct

OSHA rule requiring all contractors to educate employees about the hazardous chemicals at work

two straight ladders connected so the length can be adjusted

a man-made cut, cavity, trench, or depression in an earth surface, formed by removing earth

a narrow excavation or _____ ;below ground, generally deeper than it is wide.

When working 6' or more above ground, your harness must have a(n) ____ attached to an anchor.

a device that interupts & de-energizes a circuit to protect from electrocution

houses the circuits that distribute electricity throughout a structure

which ladder is self-supporting with two sections hinged at the top

a chip or fragment of rock or soil that has broken off from the main mass

Set up a proctective ______ when welding with other workers present

the flame cutting process results in oxides that mix with molten iron and produce ______

a formal procedure for taking equipment out of service and ensuring it cannot be operated.

to prevent a cave-in, follow OSHA regulations for ______ up a trench.

on scaffolding over 10 feet, use _____ , diagonal from bottom to top of another rail to support

a good _____ helps to prevent or correct conditions that can cause accidents.

the connection between electrical equipment or circuit and the Earth

If a work area has been _____; it has material at least 2" thick and 6" wide for flooring

a(n) _____ is caused from even a brief exposure to the ultraviolet light from arc welding.

large enough for work, but limited entry or exit; sometimes a permit is required